Lightnin Grip Loader Instructions |

AFTER MARKET MAGAZINES ONLY

Adapter INSTRUCTIONS for AFTERMARKET 10/22 Magazines.

1.) Choose the correct adapter for your magazine. Put at least one round
in your magazine and look how the back of the rimmed cartridge lines up
with the centerline of the magazine. It will be either CENTERED (Shooters
Ridge, Butler Creek), or OFF-CENTER to the left (Black Dog, RamLine,
Eagle.) Centered Ramline has longer feed lips and does not work.

OFF CENTER __________CENTER

2.) Hold the loader in your left hand, and press the adapter lock with your thumb.
With your right hand, hook the Magazine Adapter into the top of the Lightnin’
Grip Loader and swing the bottom into the slot. Take your thumb off of the lock
button. It should pop out to the locked position when the adapter is fully seated.

HOOK AND LATCH

3.) Insert your magazine into the adapter until the small magazine pin hooks
under the latch.

INSERT MAGAZINE

LIGHTNIN’ GRIP LOADER INSTRUCTIONS

1.) Slide open the Bullet Reservoir Cover and drop in up to (50) 22LR cartridges.

2.) Close cover. Gently shake the Lightnin’ Grip Loader, keeping it level and
the reservoir cover on top.

3.) Raise the reservoir end to slide the cartridges in to the Loading Channel.

4.) Repeat #2 and #3 until the Loading Channel fills sufficiently.

FILL WITH AMMO

5.) Raise the reservoir end and smoothly squeeze the trigger to load a round
into the magazine. The trigger needs to return to the nearly out position to
seat the round and stage another bullet for loading. It is usually a good idea
to count the bullets going in to know when to stop. It is possible to force in an
extra round.NOTE: Quickly snapping the trigger in can cause the bullets to bounce in some
magazines and “hook” the rims in the wrong direction making them hard to get out.
Sometimes a hard rap on the bottom of the magazine with your palm or on a book
will bounce the bullets to unhook them.

ALIGN BULLETS

TIPS:

Some 22LR cartridges are real sticky with wax lube. After filling the reservoir, give
them a shot of Remington (Rem Oil) Teflon Spray Lube. Only a small amount is
needed.

CAUTION: the unit is molded from Lexan, and some lubes will attach it.

Not all magazines fit the same; you may need to apply a little seating pressure
against the magazine as you are loading it. As Pictured here.

Periodically take a look at our website for updated tips.

HOLD MAG SEATED AND SQUEEZE TRIGGER.